| Author |
Message |
    
307
| | Posted on Thursday, April 24, 2003 - 7:23 pm: | 
|
Problem: Channel Display Dead!
Fix:
1) Remove covers (top and bottom)
2) Remove all knobs
3) Remove face plate (2 screws on each side)
4) Remove single screw on each side of knob plate.
5) Tilt knob plate towards you just enough to see the back side of the channel selector.
6) You will see a broken wire on the left front corner of the channel readout board.
7) Solder the wire back on the the "PAD" that is closest to the front left edge of the channel display board.
8) re-assemble. |
|
