Copper Talk » Modifications » Radios » Need to 'un-modify' Voyage VR 9000 « Previous Next »

Author Message
Top of pagePrevious messageNext messageBottom of page Link to this message

Tech833
Intermediate Member
Username: Tech833

Post Number: 118
Registered: 12-2001
Posted on Saturday, September 02, 2006 - 3:05 am:   Edit Post Delete Post    Move Post (Moderator/Admin Only)

Hi guys and gals.

I have a Voyage VR 9000 radio on my bench that needs to become a beacon on the 10 meter band. I want to remove the CB add-on modification and make it a 10-meter only radio again before it leaves the bench.

I have searched all the archives here and found nothing. I know this radio is similar to a Galaxy 88, and I have looked up all the 'modification' info on it. However, none of that info or the diagrams match this radio.

Can someone help? Possibly with pictures?

Thanks!
Top of pagePrevious messageNext messageBottom of page Link to this message

Patzerozero
Senior Member
Username: Patzerozero

Post Number: 3182
Registered: 7-2004


Posted on Saturday, September 02, 2006 - 6:08 pm:   Edit Post Delete Post    Move Post (Moderator/Admin Only)

Voyage VR9000 Frequency Expansion

Expand your radio to get 25.565MHz - 28.305MHz

Remove Top of Case ( Reveal Solder Side of Board ).

Directly back from the Channel Selector you will see 4 or 5 small resistors (1/8 watt).

These resistors jump across the PLL.

They are very obviously shorting the PLL Section out.

Remove these resistors.

When you turn the radio back on, you will have coverage from 25.565 to 28.305.

You lose some of your 10 meter coverage, but gain a LOT of lower frequencies.

I believe Band C or D is the CB Band


best i can help you with, paul. i don't know the values of these resistors, or if different versions of this radio exist with different mods even.
Top of pagePrevious messageNext messageBottom of page Link to this message

Chickenbone
New member
Username: Chickenbone

Post Number: 7
Registered: 8-2006
Posted on Saturday, September 02, 2006 - 9:38 pm:   Edit Post Delete Post    Move Post (Moderator/Admin Only)

1/8 watt 100 ohm resistors. I had 4 on the conversion I did. Good luck. Bill
Top of pagePrevious messageNext messageBottom of page Link to this message

Tech833
Intermediate Member
Username: Tech833

Post Number: 119
Registered: 12-2001
Posted on Sunday, September 03, 2006 - 1:26 am:   Edit Post Delete Post    Move Post (Moderator/Admin Only)

Thank you.

HOWEVER... I am not simply removing some resisotrs, I need to ADD them! Therefore, I need to know WHERE to add them to 'un-modify' the radio. Any help?
Top of pagePrevious messageNext messageBottom of page Link to this message

Tech833
Intermediate Member
Username: Tech833

Post Number: 120
Registered: 12-2001
Posted on Sunday, September 03, 2006 - 11:08 am:   Edit Post Delete Post    Move Post (Moderator/Admin Only)

Thanks again.

I had already looked there, but none of the pictures or descriptions matched this radio. Just for grins, went back and looked again this morning. The ONE picture I had not opened was the CX3300 New version. There it was! Thanks a lot!

Add Your Message Here
Post:
Username: Posting Information:
This is a private posting area. Only registered users and moderators may post messages here.
Password:
Options: Enable HTML code in message
Automatically activate URLs in message
Action: