Copper Talk » Ask The Tech » Amplifiers » TUNING A BLJ 600A LINEAR AMP « Previous Next »

Author Message
Top of pagePrevious messageNext messageBottom of page Link to this message

Clark514
Member
Username: Clark514

Post Number: 64
Registered: 6-2003


Posted on Saturday, June 17, 2006 - 8:28 pm:   Edit Post Delete Post    Move Post (Moderator/Admin Only)
I DONT EVEN KNOW WHERE TO START.....SHOULD HAVE WROTE IT DOWN WHEN THE GUY SHOWED ME THAT IT WORKS......SOOOOOO HERE I AM SCARED TO DO ANYTHING THAT I MIGHT MESS UP SOMETHING ...SO ANY HELP WILL BE A BLESSING.....IT HAS A OUTPUT/LEVEL KNOB....A RF/GAIN KNOB....A DRIVE KNOB.....A PLATE KNOB AND A LOAD KNOB.....SOOOOOOOOO WHERE DO WE START........THANKS FOR ANY HELP.......CLARK514
Top of pagePrevious messageNext messageBottom of page Link to this message

Bronzepony
Member
Username: Bronzepony

Post Number: 64
Registered: 12-2005
Posted on Thursday, August 17, 2006 - 12:37 am:   Edit Post Delete Post    Move Post (Moderator/Admin Only)
Glad to see some out here with a Blj I run a BLJ 400A and a Buddy runs a BLK 750 these were all built By one man Lives real close to me. To tune it output on low tune Drive for max then Plate then load then back out of drive 1/4 of a no. then open up output and tune like before. If it has been mod. to be like a BLK you will run on 100 watts and see it swing if not it will pretty much stay at what you are dead keying. Max Dead Key with 100% tubes is 625.

Add Your Message Here
Post:
Username: Posting Information:
This is a private posting area. Only registered users and moderators may post messages here.
Password:
Options: Enable HTML code in message
Automatically activate URLs in message
Action: