Copper Talk » Ask The Tech » General Technical Questions » Basic "Electronics 101" question « Previous Next »

Author Message
Top of pagePrevious messageNext messageBottom of page Link to this message

Starface
Advanced Member
Username: Starface

Post Number: 629
Registered: 1-2005


Posted on Tuesday, May 30, 2006 - 5:11 pm:   Edit Post Delete Post    Move Post (Moderator/Admin Only)

I am working on a portable radio cabinet and have installed a 5"
cooling fan in the back. The fan is out of a PC and runs on 12VDC.

When I hook it up to the power supply, it runs perfectly - except
that it's a bit fast for what I want. (Also noisy)

I want to slow it down so I added a simple variable resistor pot
rated at 25 ohms. This helped some. It slowed the fan down enough
where it doesn't blow the knobs off my radio but I would like to be
able to adjust it more. What would be perfect is to add a resistor
in series to drop the voltage even more...

The question is... What value resistor and what size should I use?

It would be nice if the pot would go from "off" to "mid speed"
instead of from "mid speed" to "very fast" as it is now.

Anyone have any ideas?

Starface
KI4NBE
Top of pagePrevious messageNext messageBottom of page Link to this message

Tech291
Moderator
Username: Tech291

Post Number: 395
Registered: 11-2004


Posted on Tuesday, May 30, 2006 - 8:13 pm:   Edit Post Delete Post    Move Post (Moderator/Admin Only)

George,
Most of those fans have a tach circuit in them and wont run below a certain speed.look up a simple varible voltage regulator using a LM-317 i.c.,Also check on a fan controller/tempeture display for a computer tower.

TECH291
CEF#291/CVC#6
KC8ZPJ
Top of pagePrevious messageNext messageBottom of page Link to this message

Chad
Advanced Member
Username: Chad

Post Number: 874
Registered: 11-2004


Posted on Tuesday, May 30, 2006 - 8:16 pm:   Edit Post Delete Post    Move Post (Moderator/Admin Only)

Most computer fans are brushless designs and are not driven from current. Inside there is a small PC board and driver circuitry to enable it to... you guessed it... maintain a constant speed. This is important in a computer because as the power supply is under load it's more important to maintain fan velocity. There are adjustable speed fans out there, check the local computer warehouses, they are niot that much more money.

Chad
Top of pagePrevious messageNext messageBottom of page Link to this message

Starface
Advanced Member
Username: Starface

Post Number: 631
Registered: 1-2005


Posted on Tuesday, May 30, 2006 - 10:17 pm:   Edit Post Delete Post    Move Post (Moderator/Admin Only)

Thanks for the help

George
KI4NBE

Add Your Message Here
Post:
Username: Posting Information:
This is a private posting area. Only registered users and moderators may post messages here.
Password:
Options: Enable HTML code in message
Automatically activate URLs in message
Action: