| Author |
Message |
    
Yaesujohn
Junior Member
Username: Yaesujohn
Post Number: 16
Registered: 9-2005
| | Posted on Saturday, May 13, 2006 - 2:31 am: | 
|
I recently installed a TUG8 on my President Madison (5-pin 8719 chassis). I used wiring info I found here, and I've confirmed thru another source that it is indeed the correct wiring. Transmit works fine, but I have a problem with a receive squeal. It only appears after a few minutes. If I key the mic it goes away, but reappears after a couple of minutes. It will also go away if I open the squelch or if someone breaks the squelch. But after a couple of minutes it returns. I've even tried leaving the squelch open, but it still comes back if I have the volume control turned all the way down. The only way I can keep it away is to leave the squelch off and the volume turned down, but not all the way. Any ideas, folks? |
Hollowpoint445
Senior Member
Username: Hollowpoint445
Post Number: 1222
Registered: 6-2004
| | Posted on Saturday, May 13, 2006 - 9:29 am: |
|
How did you wire it? |
Tech808
Moderator
Username: Tech808
Post Number: 9979
Registered: 8-2002
| | Posted on Saturday, May 13, 2006 - 10:20 am: |
|
Yaesujohn,
Double check to make sure it is wired as follow's:
PIN #1 ~ WHITE
PIN #2 ~ SHIELD
PIN #3 ~ RED
PIN #4 ~ N/C / OPEN
PIN #5 ~ N/C / OPEN
BLACK N/C
Electronic Switching
Also Double check to make sure there are no stray wires touching any of the other wires inside the base of the mic and in your 5 pin radio connector.
Hope this help's,
Lon
Tech808
CEF808
N9CEF
CVC#2 |
|
