| Author |
Message |
    
Scannersam
New member
Username: Scannersam
Post Number: 5
Registered: 6-2002
| | Posted on Saturday, December 03, 2005 - 1:47 am: | 
|
Need help on how to install a PG-1 PING sound toy /module in a new old type COBRA 148 GTL. I have no instructions . Need to make sure where each wire goes and where can I pick up the 12V power source. The PING unit is also new and has a Yellow/Black/Red /Green wire. and help can e-mail me or just post .Thank you SCANNERSAM |
Wildrat
Intermediate Member
Username: Wildrat
Post Number: 406
Registered: 12-2003
| | Posted on Saturday, December 03, 2005 - 9:50 am: |
|
If I were you I'd do Google searcch and see if you can find instructions. I could only help with two wires and thats only if they are coded correctly. I have never heard of this module. It probably will be ssimilar to other modules though of the same type and use, so the wiring hook up should be the same as long as the wires are coded the same. Sorry.
Wildrat |
Patzerozero
Senior Member
Username: Patzerozero
Post Number: 2002
Registered: 7-2004
| | Posted on Saturday, December 03, 2005 - 10:33 am: |
|
obviously, black is ground. put the red wire to the 'on' side of the on off switch. as for the other 2, 1 wire goes to the audio wire off the mic jack-that's pin 1, & the other to the keying side of mic jack-pin 5. don't know which would be yellow or green though. get red & black hooked up, & try the other 2 one way then the other til you find it. |
