Copper Talk » Ask The Tech » Radio's Mobile » Archived Messages » Cobra 19 DX III - Keeps going back to Channel 9 « Previous Next »

Author Message
Top of pagePrevious messageNext messageBottom of page Link to this message

Cindy2
New member
Username: Cindy2

Post Number: 1
Registered: 6-2005
Posted on Sunday, June 12, 2005 - 12:56 am:   Edit Post Delete Post    Move Post (Moderator/Admin Only)

I just bought a Cobra 19 DX III. For some unknown reason, it keeps switching back to channel 9 while I'm driving down the road.

I have wiggled the "Channel 9" switch and wiggled the wires and I can't it to do it. But driving down the road, it will switch back to channel 9 all by itself. Very annoying!!

Any suggestions? Or should I just send it back to Cobra? It works great other than that.

Cindy2
Top of pagePrevious messageNext messageBottom of page Link to this message

Tech291
Moderator
Username: Tech291

Post Number: 194
Registered: 11-2004


Posted on Sunday, June 12, 2005 - 7:30 am:   Edit Post Delete Post    Move Post (Moderator/Admin Only)

Welcome to the forum Cindy2.It sounds like you may have a loose power connection.If your using a cig-lighter plug that could be the culprit,if so try having it wired directly into the fusebox or direct to the battery.the laterseries of the 19's as a defult always revert to channel 9 when powered up.


tech291
CEF#291
kc8zpj
Top of pagePrevious messageNext messageBottom of page Link to this message

Wirejockey
New member
Username: Wirejockey

Post Number: 2
Registered: 6-2005


Posted on Sunday, June 12, 2005 - 8:32 am:   Edit Post Delete Post    Move Post (Moderator/Admin Only)

if ya just bought it. i'd send it back. just my 2 cents.
Top of pagePrevious messageNext messageBottom of page Link to this message

Bruce
Senior Member
Username: Bruce

Post Number: 2845
Registered: 9-2003
Posted on Sunday, June 12, 2005 - 8:51 am:   Edit Post Delete Post    Move Post (Moderator/Admin Only)

voltage dropout will cause that
Top of pagePrevious messageNext messageBottom of page Link to this message

Bigbob
Senior Member
Username: Bigbob

Post Number: 1976
Registered: 12-2001
Posted on Sunday, June 12, 2005 - 8:37 pm:   Edit Post Delete Post    Move Post (Moderator/Admin Only)

Yeah,bad connection,had a cobra that did that,cigarette lighter socket was corroded,wired it to fuse panel,no more problem.
Top of pagePrevious messageNext messageBottom of page Link to this message

Cindy2
New member
Username: Cindy2

Post Number: 2
Registered: 6-2005
Posted on Monday, June 13, 2005 - 10:05 pm:   Edit Post Delete Post    Move Post (Moderator/Admin Only)

Thanks for the suggestions guys. I checked the volt at the radio and it was 12 volts.

I also wiggled every wire I could see and could not get it to change back to channel 9. I left it on all night and it was still on channel 4 when I got up. Maybe I need to be driving for it to happen?

Anyway, I moved my power wire to an "always on" wire and I will try that. The first wire I tied into was a switched with the car key.

Cindy2
Top of pagePrevious messageNext messageBottom of page Link to this message

Deer_hunter
New member
Username: Deer_hunter

Post Number: 1
Registered: 8-2005
Posted on Thursday, August 18, 2005 - 8:49 am:   Edit Post Delete Post    Move Post (Moderator/Admin Only)

Cindy2,have same radio. Whenever power up it goes to Ch. 1. I read in manual that to maintain constant channel selection as turned off the power must be constantly on(direct to battery). Just have to remember to turn off. This is an annoying feature of this radio and the Cobra handheld. Would not buy it again because of this.
Top of pagePrevious messageNext messageBottom of page Link to this message

Tech808
Moderator
Username: Tech808

Post Number: 7339
Registered: 8-2002


Posted on Thursday, September 22, 2005 - 12:53 am:   Edit Post Delete Post    Move Post (Moderator/Admin Only)

.
Top of pagePrevious messageNext messageBottom of page Link to this message

Kx_kidd
New member
Username: Kx_kidd

Post Number: 1
Registered: 12-2006
Posted on Friday, December 29, 2006 - 12:47 pm:   Edit Post Delete Post    Move Post (Moderator/Admin Only)

Do you techs have an opinion about this radio (Cobra 19 DX III)? I have this radio and was wondering if it is worth getting aligned and tuned. The cost of the alignment will probably be close to what I paid for the radio new. Or should I just trash it and start over with something else? Thanks.
Top of pagePrevious messageNext messageBottom of page Link to this message

Hotwire
Senior Member
Username: Hotwire

Post Number: 2152
Registered: 1-2005


Posted on Saturday, December 30, 2006 - 10:38 pm:   Edit Post Delete Post    Move Post (Moderator/Admin Only)

Kx kidd, Don't trash it! It's not a bad starter radio. Really no need to worry about an alignment(tune). They are usually just fine out of the box. Also not worth spending money to have the transmitter peaked. Might be able to get a watt or two higher output depending on the radio.
Just get a great antenna, tune the antenna and it will work fine. If cb grows on you then you will out grow the radio and want something better. Put it back in the box and keep it. One day you will want to get it back out again. If you really despise the radio then sell it but whatever you do don't trash it!
Kenny
cef491(27.115lsb)
2sf491(27.555usb)
Indiana

Add Your Message Here
Post:
Username: Posting Information:
This is a private posting area. Only registered users and moderators may post messages here.
Password:
Options: Enable HTML code in message
Automatically activate URLs in message
Action: