Copper Talk » Ask The Tech » Radio's Mobile » Archived Messages » Beep Volume « Previous Next »

Author Message
Top of pagePrevious messageNext messageBottom of page Link to this message

Al_lafon
Junior Member
Username: Al_lafon

Post Number: 14
Registered: 3-2005
Posted on Sunday, May 08, 2005 - 11:49 pm:   Edit Post Delete Post    Move Post (Moderator/Admin Only)

Hello i have a superstar 3900 gold plus main
board is EPT690010c. Ok i get the beep up and runnig but feel its far to loud like to bring
it down some. Can not find info for this ?

Thanks AL
Top of pagePrevious messageNext messageBottom of page Link to this message

Patzerozero
Advanced Member
Username: Patzerozero

Post Number: 758
Registered: 7-2004
Posted on Monday, May 09, 2005 - 2:44 pm:   Edit Post Delete Post    Move Post (Moderator/Admin Only)

al, experiment with a resistor between 10k & 100k soldered in series with the wire that goes to the 'audio' pin on the back of the mic socket. POSSIBLY a blue wire.
Top of pagePrevious messageNext messageBottom of page Link to this message

Vanillagorilla
Member
Username: Vanillagorilla

Post Number: 58
Registered: 4-2005


Posted on Tuesday, June 07, 2005 - 3:03 pm:   Edit Post Delete Post    Move Post (Moderator/Admin Only)


I have the same radio and was told it had no "beep"? Is it disabled by the factory or did you install aftermarket? Just wondering.. If its factory disabled how might I "enable" it? I'd put a switch on it of course...Thanks and GOOD LUCK WITH YOURS!



Hank '905
CEF 559
Top of pagePrevious messageNext messageBottom of page Link to this message

Jon666
Intermediate Member
Username: Jon666

Post Number: 349
Registered: 11-2003


Posted on Thursday, June 09, 2005 - 6:20 pm:   Edit Post Delete Post    Move Post (Moderator/Admin Only)

its a jumper j9
has been cut it is in the front of the radio on the board just put a switch on it

Add Your Message Here
Post:
Username: Posting Information:
This is a private posting area. Only registered users and moderators may post messages here.
Password:
Options: Enable HTML code in message
Automatically activate URLs in message
Action: