Author |
Message |
Maxwedge2
| Posted on Friday, November 30, 2001 - 11:50 am: |
|
I have a problem with my 3300 Ranger mobile rig. When ever I remove the radio from my truck and attempt to hook it back up, I can't get it to come back to 11 meters. The display reads 28.000 mhz and after about 1 hour or so and a combination of turning the rig on and off numerous times, it will suddenly come back to 26.000 mhz. I then can go to the desired frequency and not have any problems until I disrupt the power again. I leave the squelch selector in the off position when trying to restore power and once the radio comes back on to 26.000 mhz, I move the squelch selector back up just above the click or dentent point. Everything is fine at that point and the radio will function properly, it's only after there is a power disconnect where the problem occurs. I have no schematic for it and everything looks ok inside. Any help would be appreciated. Jim maxwedge2 |
307
| Posted on Friday, November 30, 2001 - 1:10 pm: |
|
Look in the Open Forum , I posted your answer there in you first question... 307 |
|