| Author |
Message |
    
Ashtray
Junior Member
Username: Ashtray
Post Number: 18
Registered: 1-2005
| | Posted on Saturday, February 05, 2005 - 7:12 pm: | 
|
I'll try posting this here to see if I can work up a response. Didn't work so well in the open forum. Anyways...Can my Palomar 300 be modified to work on ssb?
thanks for any replies |
Bruce
Senior Member
Username: Bruce
Post Number: 2177
Registered: 9-2003
| | Posted on Saturday, February 05, 2005 - 8:08 pm: |
|
most " SSB " on amps is done by adding a cap to slow up the drop out of the relay you can do this your self. |
Tech291
Moderator
Username: Tech291
Post Number: 60
Registered: 11-2004
| | Posted on Saturday, February 05, 2005 - 11:10 pm: |
|
ashtray,
try experimenting with capicitors of same voltage rating but lower capacity to shorten the delay time for relay dropout. |
Ashtray
Junior Member
Username: Ashtray
Post Number: 22
Registered: 1-2005
| | Posted on Thursday, February 10, 2005 - 9:24 pm: |
|
Ok..so where abouts to the relay would I add this cap and could you reccomend a good voltage/cap rating to start with.
thanks. |
Ashtray
Junior Member
Username: Ashtray
Post Number: 35
Registered: 1-2005
| | Posted on Friday, February 18, 2005 - 7:14 pm: |
|
suggestions?
Ashtray
CEF #299 |
Tech291
Moderator
Username: Tech291
Post Number: 90
Registered: 11-2004
| | Posted on Friday, February 18, 2005 - 8:03 pm: |
|
sorry for the "Delayed"reply ashtray,just caught back up with this thread.I installed a 680uf/25volt in my palomar250(auto ssb) to get a better delay.the + side of the cap connects to the emitter of the switching transistor and the - goes to ground.you can also add a switch to cut it in and out.for shorter delay use a lower uf cap,longer delay use a higher uf.
tech291
CEF#291
kc8zpj
|
Im4jc
Junior Member
Username: Im4jc
Post Number: 49
Registered: 11-2005
| | Posted on Sunday, January 15, 2006 - 12:50 pm: |
|
I have a Palomar 250 Elite and want to add a switch to the cap so that I can turn off the delay when not running SSB. Does anyone know which cap it is? I'm only at home for today before I hit the road again and would like to know so that I can have a CB shop do it.
Thx. |
Im4jc
Member
Username: Im4jc
Post Number: 55
Registered: 11-2005
| | Posted on Sunday, January 15, 2006 - 7:30 pm: |
|
Nevermind. Therealporkchop ansewred my question here: http://www.copperelectronics.com/cgi-bin/discus4/show.cgi?tpc=34&post=118537#POST118537 |
