Copper Talk » Ask The Tech » General Technical Questions » Archived Messages » How much swing? « Previous Next »

Author Message
Top of pagePrevious messageNext messageBottom of page Link to this message

Airplane1
Intermediate Member
Username: Airplane1

Post Number: 206
Registered: 5-2004
Posted on Friday, October 29, 2004 - 7:29 am:   Edit Post Delete Post    Move Post (Moderator/Admin Only)

If you are running 1 watt dead key AM into an amp what should the radio be swinging?
I have my grant xl set at 1 watt dead key and it swings about 2 watts when I say aaaahhhhddeeeeeoooo, I that fine or should it swing more?

Thanks
Top of pagePrevious messageNext messageBottom of page Link to this message

Patzerozero
Intermediate Member
Username: Patzerozero

Post Number: 164
Registered: 7-2004
Posted on Friday, October 29, 2004 - 5:39 pm:   Edit Post Delete Post    Move Post (Moderator/Admin Only)

depends on whether meter is reading peak or rms, and whether radio has been peaked/tuned/clipped and where mic gain is set. my xl has been peaked, limiter clipped on a switch and variable output (wired in place of rf gain). on diamond sx100 meter, rms @ 1w key, swings 4, @4w key swings 7. peak 1w key swings 12, 4w key swings 14. with limiter switched open, swing goes up a couple watts. no fancy (npc) mods done to this radio, just basics.
Top of pagePrevious messageNext messageBottom of page Link to this message

Airplane1
Intermediate Member
Username: Airplane1

Post Number: 208
Registered: 5-2004
Posted on Friday, October 29, 2004 - 6:25 pm:   Edit Post Delete Post    Move Post (Moderator/Admin Only)

Patzerozero,
the radio is stock and only opened by me to adjust the AM power to 1 watt and SSB to about 8 watts.
I like the way you have your radio set up, does it sound good on the air?
Did you do the mods your self?
The meter I`m useing is a small radio shack SWR/Power/Modulation.
Thanks

Add Your Message Here
Post:
Username: Posting Information:
This is a private posting area. Only registered users and moderators may post messages here.
Password:
Options: Enable HTML code in message
Automatically activate URLs in message
Action: