| Author |
Message |
    
Creepyrat
| | Posted on Monday, February 16, 2004 - 3:06 pm: | 
|
i looked through lots of posts but im trying to confirm some info, do i need to connect any wires or move a jumper in my kl-60 amp before i connect it to the midland?
thanks for your help. |
Tech808
| | Posted on Monday, February 16, 2004 - 4:15 pm: |
|
Creepyrat,
If you order the KL 60 from Copper it will arrive ready to go / use.
Hook up a Coax Jumper between the Radio and your Amplifier and hook your Antenna to the Amplifier.
Make Sure! You have the DEAD KEY on the Radio set to 2 or 2 1/2 Watts and it should work very well for you.
These Smaller KLV Amplifiers do not take a lot of drive to perform well. And Overdiving them will blow them up QUICK!
Hope this helps.
Lon
Tech808 |
Creepyrat
| | Posted on Monday, February 16, 2004 - 7:33 pm: |
|
i didnt order it from copper, i didnt find your fine forum untill later. but it has been a great deal of help. |
Creepyrat
New member
Username: Creepyrat
Post Number: 6
Registered: 2-2004
| | Posted on Wednesday, February 18, 2004 - 5:21 pm: |
|
lol never mind i just had to get it and take it apart, the answer was very obvious |
Mikefromms
Intermediate Member
Username: Mikefromms
Post Number: 101
Registered: 6-2003
| | Posted on Saturday, February 21, 2004 - 9:32 am: |
|
Curiousity killed the rat...I mean....cat.
mikefromms |
Creepyrat
New member
Username: Creepyrat
Post Number: 9
Registered: 2-2004
| | Posted on Monday, February 23, 2004 - 12:53 am: |
|
lol naa im still alive havnt tried running the kl yet though |
