Copper Talk » Ask The Tech » General Technical Questions » Archived Messages » Solder problem « Previous Next »

Author Message
Top of pagePrevious messageNext messageBottom of page Link to this message

Teham
Posted on Friday, January 30, 2004 - 3:19 pm:   Edit Post Delete Post    Move Post (Moderator/Admin Only)
How do you get solder to take when there is too much flux on a chip and trace?
Top of pagePrevious messageNext messageBottom of page Link to this message

Jose22
Posted on Friday, January 30, 2004 - 6:28 pm:   Edit Post Delete Post    Move Post (Moderator/Admin Only)
Take small knife and scrape off excess. I use a hobby knife. I then will clean with q-tip and alcohol. Use good quality solder made for electronics. I like the highest silver/tin % i can get.

Good luck
Top of pagePrevious messageNext messageBottom of page Link to this message

Tech8541
Posted on Friday, January 30, 2004 - 10:08 pm:   Edit Post Delete Post    Move Post (Moderator/Admin Only)
when you say chip, are you talking about an smt device?

Add Your Message Here
Post:
Username: Posting Information:
This is a private posting area. Only registered users and moderators may post messages here.
Password:
Options: Enable HTML code in message
Automatically activate URLs in message
Action: