Copper Talk » Ask The Tech » Radio's Mobile » Archived Messages » Galaxy 99V « Previous Next »

Author Message
Top of pagePrevious messageNext messageBottom of page Link to this message

Stepchild
Posted on Tuesday, March 04, 2003 - 1:34 pm:   Edit Post Delete Post    Move Post (Moderator/Admin Only)

Can anyone tell me how to adjust meter on mt 99? My watt meter shows it to dead key 10w and peak at 25w but the radio meter shows about 7 or 8 and peak at 12 to 15w.I'd like to adjust this if I can so I don't have to run my big dosy meter inline all the time.If not,were can I find a smaller 1000w forward swing meter??? thanks Stepchild
Top of pagePrevious messageNext messageBottom of page Link to this message

Dx431
Posted on Tuesday, March 04, 2003 - 1:56 pm:   Edit Post Delete Post    Move Post (Moderator/Admin Only)

Stepchild,


VR 1....AM/FM S-Meter
VR 2....SSB S-Meter
VR 3....SSB Squelch Range
VR 4....AM/FM Squelch Range
VR 5.....FM Deviation
VR 7....SSB Carrier Balance
VR 8....RF Meter
VR10...Final Bias
VR11...Driver Bias
VR12...SSB ALC
VR13...AM/FM High Power
VR14...AM Modulation
VR16...AM/FM Low Power
VR20...Final Bias
VR21...TX Offset
Unmarked VR in R189..AM/FM Medium Power for DX 77HML only

Hope this helps.
431
Top of pagePrevious messageNext messageBottom of page Link to this message

Viking
Posted on Tuesday, March 04, 2003 - 3:55 pm:   Edit Post Delete Post    Move Post (Moderator/Admin Only)

Set mode to AM, MIKE GAIN at minimum.
Connect wattmeter to ANT output.
Adjust VR8 so panel meter agrees with Wattmeter.
Top of pagePrevious messageNext messageBottom of page Link to this message

Stepchild
Posted on Tuesday, March 04, 2003 - 9:38 pm:   Edit Post Delete Post    Move Post (Moderator/Admin Only)

Thanks guys,I'll give it a try.thanks for the rest DX431 that may be helpful in the future
Stepchild

Add Your Message Here
Post:
Username: Posting Information:
This is a private posting area. Only registered users and moderators may post messages here.
Password:
Options: Enable HTML code in message
Automatically activate URLs in message
Action: