| Author |
Message |
    
SONOMA
| | Posted on Saturday, August 18, 2001 - 10:36 pm: | 
|
I HAVE A SUPER STAR 121 AND WANT TO OPEN UP THE MODULATION AND PEAK AND TUNE THE OUTPUT ON THE LOW AND HIGH SIDE.CAN YOU LIST THE AREAS I NEED TO DO THIS AT SUCH IF THERE IS A RESISTER TO CUT OUT FOR MODULATION AND LOCATION AND LOCATIONS OF POWER SUCH AS VR4 ETC.THANKS SONOMA! |
SONOMA
| | Posted on Monday, August 20, 2001 - 10:21 pm: |
|
I HAVE THE SUPER STAR 121 AND DID NOT GET AN ANSWER FROM YOU FOR THE POWER MODS AND MODULATION.JUST WANTING TO KNOW IF YOU HAVE ANY INFO ON IT .PS I JUST RECEIVED YOUR NUMBER 9 VIDEO TAPE ON THE EAGLE SIDEWINDER 400 AND YOU HAD MENTIONED IN THE FORUM YOU HAD PUT A AMENDUM FOR THE NEW MOD FOR CONVERSION TO 400 CHANNELS ON THE PUSH ON CONECTOR NOT BEING THERE AS EVERYONE HAS BEEN TRING TO CONVERT WITHOUT THE PINS ON THE SMALL CIRCUIT BOARD.MY TAPE DID NOT SHOW THE NEW CONVERSION.HOPE YOU HAVE SOME IHFO ON THE SS121 FOR ME.THANKS SONOMA |
Tech181 (Tech181)
| | Posted on Tuesday, August 21, 2001 - 12:00 am: |
|
Sonoma,
The Superstar 121 with the EPT120112Z board uses the following adjustments.
VR12 Low Power MOD
VR14 Hi Power MOD
VR13 AM High Power
VR16 AM Low Power
TR32 MOD Limiter
|
SONOMA
| | Posted on Tuesday, August 21, 2001 - 1:07 am: |
|
THANKS 121 THE INFO YOU SENT WAS JUST WHAT I NEEDED .SONOMA |
SONOMA
| | Posted on Tuesday, August 21, 2001 - 3:29 am: |
|
HEY 181 I MUST OF HAD A DEAD MOMENT .I THANKED YOU FOR YOUR HELP AND CALLED YOU 121 SORRY ABOUT THAT. ANYWAY ,THANKS AGAIN THE RIGHT WAY |
Tech181 (Tech181)
| | Posted on Friday, August 24, 2001 - 12:54 am: |
|
Sonoma,
Wanna add a +10 KHz jump to that radio? Here's the info. This works with radios with the EPT120112Z board...
On the component side of the board...
1) Unsolder J25 (jumper)
2) Solder a 4.7K 1/4 watt transistor in place of J25, and in then run a lead from leg of the newly installed transistor closest to J28 (the left) to one pole on a SPST toggle switch.
3) Solder another lead from the other pole on the SPST toggle to J27.
That's it!
|
