Copper Talk » Ask The Tech » Amplifiers » I need a tech! « Previous Next »

Author Message
Top of pagePrevious messageNext messageBottom of page Link to this message

bigfoot
Posted on Friday, August 17, 2001 - 3:59 pm:   Edit Post Delete Post    Move Post (Moderator/Admin Only)
Some has to know, can I bypass the 6 position power control on my KLV 550? The amp is new but the switch is bad. There is a small board attached to the switch itself, and this board is soldered to the main board in three places, can I just run a jumper across these connections??????
I am grateful for any info.
bigfoot
Top of pagePrevious messageNext messageBottom of page Link to this message

Bigfoot
Posted on Thursday, August 30, 2001 - 4:05 pm:   Edit Post Delete Post    Move Post (Moderator/Admin Only)
anyone?
Top of pagePrevious messageNext messageBottom of page Link to this message

Anonymous
Posted on Sunday, September 02, 2001 - 12:17 am:   Edit Post Delete Post    Move Post (Moderator/Admin Only)
Bigfoot I would reccomend that you take it to a good shop and have the swith repaired if possible. Its a lot cheaper that smoking you box. Probally repaired for $50 or less. Or bypassed repaired or wired for high by someone who knows what they are doing. I think that will be your best bet. Good luck Daveb

Add Your Message Here
Post:
Username: Posting Information:
This is a private posting area. Only registered users and moderators may post messages here.
Password:
Options: Enable HTML code in message
Automatically activate URLs in message
Action: