| Author |
Message |
    
Flybynight
| | Posted on Tuesday, October 29, 2002 - 12:48 pm: | 
|
I have an RCI-2950 that has the new version cpu board with the capacitor instead of battery.When unit is powered up,the orange light's will come on but no display.I'm thinking the cpu is bad.Is there any way to check to be sure the cpu is bad?Any voltage chart's to go by?The Board number is DPT295040Z. |
Ss8541
| | Posted on Tuesday, October 29, 2002 - 10:35 pm: |
|
there is a 5volt or 8volt reg on that board(i'm pretty sure it is 5v). there is also a 4.00mhz xtal on that board. these are the 1st things that i would check(off the top of my head without a processor schem in hand). if it was more than that, the whole processor can be replaced for less than $100. |
Spun
| | Posted on Tuesday, December 17, 2002 - 3:08 pm: |
|
Flybynight,
Did you find the problem? I have the non-battery version 2950 and my display has died. I'm wanting to get it back up and running.
Thanks |
Flybynight
| | Posted on Wednesday, December 18, 2002 - 4:16 am: |
|
Yes i did.I had to replace the cpu/display board.My board number was DPT295040Z.Ordered the board for $55.00 plus shiping.Radio work's just fine now. |
Znut
Junior Member
Username: Znut
Post Number: 684
Registered: 1-2002
| | Posted on Friday, February 20, 2004 - 10:15 am: |
|
Do the 2950/2970DX radios have a "channel" display after conversion? Like a 40 channel readout? |
Tech808
Moderator
Username: Tech808
Post Number: 1583
Registered: 8-2002
| | Posted on Friday, February 20, 2004 - 11:25 am: |
|
Yes they do. |
Znut
Member
Username: Znut
Post Number: 685
Registered: 1-2002
| | Posted on Friday, February 20, 2004 - 3:08 pm: |
|
Thank you. |
