| Author |
Message |
    
D Wright
| | Posted on Tuesday, July 17, 2001 - 1:01 am: | 
|
Hello,
I have a BC145xl scanner with a bad audio output. I have replaced this
output several times and it does not seem to give me back the audio. I
have traced the input and have an input signal on the input pin of the
IC but I have no output on the output pin. The schematic calls for up
to 12 volts on the vcc, however I am showing 14.3 volts. If you could
help me with this I would be deeply grateful. Thanks: D Wright |
307 (307)
| | Posted on Tuesday, July 17, 2001 - 6:22 pm: |
|
Hi , if the audio amp is blowing alot , it is most likely a shorted coupling capacitor from the output of the audio IC to the speaker. My neighbor had one and it was shorted and did the same thing yours is. |
dang
| | Posted on Saturday, September 29, 2001 - 2:57 pm: |
|
Hello.
I bought a new Washington base,and right out of the box it would trasmit a churp.I sent it back to Uniden three times ,and each time they sent it right back saying it met mfg. spec's. On the third time they supposedly sent me a new radio , but if they did this new one does the same thing. I took it to a friend's house, it did the same over there I've also used the best mic, power and standard. but it makes no difference. Have you seen this before? If so, How do I fix it, if there is a fix.
Thank's |
|
