| Author |
Message |
    
oliverogle
| | Posted on Wednesday, July 11, 2001 - 12:52 pm: | 
|
Carl: Please find me the right info:
bought eagle sidewinder would like 11 meter conv info and detune to one watt
all the mods i have read say remove jumper from pins 1 -2....move to 3 -4.
This does not have the pins or the connector. There is NO ROW OF FOUR to choose from or solder.
_________________________________________________
Here's what I have....
1. I have a four pin connector with four wires coming out of the motherboard (con5) e,d,f,grn and an empty j the connector doesnt plug into.
2. next to that I have ( con1). conv 1 has the numbers 1,2,3 tthese are empty without pins(three has a bit of solder connecting a super fine piece of wire going to the other side of the circuit board but doesn't look like it really attaches to anthing but the edge of the board.
3. There is a six pin connector g,h,c,i,b,a this in (con3)
4. (con 1) is three empty spaces 3,2,1
_________________________________________________
Also I could use some info on detuning this to one watt..... not sure what to turn... didn't get a schematic with this board....
________________________________________________
all help greatly appreciated
oliver |
vernonott
| | Posted on Wednesday, July 11, 2001 - 7:27 pm: |
|
307: You're supposed to be off of vacation.These guys need your assistance.We need your assistance .Come on back to the ball field.Without the catcher we don't have a complete team. |
307 (307)
| | Posted on Thursday, July 12, 2001 - 6:12 am: |
|
Yes, I have had a lot going on this week , ANYWAYS...On the Sidewinder , Looking down into the radio , there is a small circuit board on the right side faceing you. Towards the REAR RIGHT SIDE of the small board are three holes that once had a small connector header. I believe you short the two pins closest to the rear of the small board. This should do it. |
oliverogle
| | Posted on Thursday, July 12, 2001 - 1:19 pm: |
|
307 thanks
I see the pin holes you are talking about.
I dont have any "Pins" but there are holes there for pins. .. .. .. So I will just bridge the gap one way or the other to short across there.
Will wait till I go to work late today to pick up some pins and a jumper.
Thanks
Oliver |
Anonymous
| | Posted on Friday, July 13, 2001 - 2:07 pm: |
|
307 I have the sidewinder and the info everyone needs on this radio is that the small pc board on the side rail has been turned up-side-down in a lot of them.
with a screw on one end and soldered on the other
all you have to do is remove the screw and lift the board to move the jumper. |
oliverogle
| | Posted on Sunday, July 15, 2001 - 1:45 am: |
|
that would be great....if.....if there were a jumper....hehehehe
the first thing I did was to take the board off, and thats where all those numbers came from in my specific post to 307.
307 has offered to mod it for me......
thanks for response |
|
