Copper Talk » Ask The Tech » Radio's Mobile » Archived Messages » Connex echo board? « Previous Next »

Author Message
Top of pagePrevious messageNext messageBottom of page Link to this message

Barakuda318
Posted on Tuesday, March 19, 2002 - 12:46 pm:   Edit Post Delete Post    Move Post (Moderator/Admin Only)

I have a connex echo board that I want to install in my radio. does anyone have the wireing diagram for this particular echo board, any help would be greatly appreciated thanx
73's
barakuda318
Top of pagePrevious messageNext messageBottom of page Link to this message

Jyd
Posted on Tuesday, March 19, 2002 - 1:44 pm:   Edit Post Delete Post    Move Post (Moderator/Admin Only)

the brown wire goes to a 8volt source,if you can not find a 8volt source use a 1k 1/2watt resisterto the 13.8volt source(2)solder the black to one of the metal cans.(3)unsolder audio wire from mic socket,next hook the white wire fromthe echo board(j2)to the pin on the mic socket where you removed the audio wire.(4)solder the white wire from(j1)to to the wire that was removed from the mic socket(5)solder both shields from j1 and j2 to one of the cans or pc board ground.there you go.
Top of pagePrevious messageNext messageBottom of page Link to this message

Barakuda318
Posted on Wednesday, March 20, 2002 - 12:54 am:   Edit Post Delete Post    Move Post (Moderator/Admin Only)

Thanx so very much I thought that was right but didn't want to try it till I knew for sure, I appreciate your response thanx again very much
73's
Top of pagePrevious messageNext messageBottom of page Link to this message

Jyd
Posted on Wednesday, March 20, 2002 - 4:36 pm:   Edit Post Delete Post    Move Post (Moderator/Admin Only)

your welcome.

Add Your Message Here
Post:
Username: Posting Information:
This is a private posting area. Only registered users and moderators may post messages here.
Password:
Options: Enable HTML code in message
Automatically activate URLs in message
Action: