Copper Talk » Ask The Tech » Modifications » Robyn SB 520D Modulation « Previous Next »

Author Message
Top of pagePrevious messageNext messageBottom of page Link to this message

Mrt4d
New member
Username: Mrt4d

Post Number: 3
Registered: 8-2005
Posted on Wednesday, September 05, 2007 - 9:53 am:   Edit Post Delete Post    Move Post (Moderator/Admin Only)

I have a Robyn SB 520d Base radio. I need more modulation. Modulation Is about 80%. I have turn the pot for modulation all the way. Is there a swing kit or modulater kit i can install. And where would i install the kit. The radio has 858 chip.
Top of pagePrevious messageNext messageBottom of page Link to this message

Patzerozero
Senior Member
Username: Patzerozero

Post Number: 3924
Registered: 7-2004


Posted on Saturday, September 08, 2007 - 11:25 pm:   Edit Post Delete Post    Move Post (Moderator/Admin Only)

look for mods for these radios-they're all the same:COBRA 138 139 XLR (OLD) PRESIDENT GRANT, WASINGTON,MADISON , ROYBN 510 , 520D ,TRC-449 457 AND 458.

that said:(Mike circuit changes:-)
1. UNSOLDER banded end of diode D21 and lift up.
2. UNSOLDER banded end of diode D22 and lift up.
3. SOLDER a 4.7 k resistor across where D21 and D22 was unsoldered.
4. Replace R78 (27k) with a 56k.
5. Replace R84 (4.7k) with a 2.2k.

(Transmit circuit changes:-)
1. Replace C174 (56pF NPO) with a 82pF NPO ceramic capacitor.
2. Replace C173 (180pF NPO) with a 220pF NPO ceramic capacitor.
3. Re-tune coils L32,L30,L29,L28 and VR8 for maximum forward AM power.

The AM regulator 2SC1419 is WEAK. UNSOLDER it and toss it in the trash.
Replace it with a GE-66, ECG-152 or a NTE-152.
Relay buzzes on SSB, no am transmit, lights go dim, or the fuse pops sometimes?
Replace C179 ( a 2.2uF 25v tantalum cap located near finals) with a standard 2.2uF electrolytic capacitor.


PAY ATTENTION to the "+" and "-"!!!

Add Your Message Here
Post:
Username: Posting Information:
This is a private posting area. Only registered users and moderators may post messages here.
Password:
Options: Enable HTML code in message
Automatically activate URLs in message
Action: