| Author |
Message |
    
Af579
Junior Member
Username: Af579
Post Number: 26
Registered: 6-2003
| | Posted on Thursday, February 10, 2005 - 6:13 pm: | 
|
ok I can't find my manuals. Anyone know the stock mic wiring "color to pin" for the Ts 690s? and the combo to wire the turner expander 500? |
Racer X (Unregistered Guest)
Unregistered guest
| | Posted on Thursday, February 10, 2005 - 6:40 pm: |
|
Kenwood Mic Pinout:
1 - Mic Audio
2 - STBY (PTT)
3 - Down
4 - Up
5 - +8V
6 - NC
7 - GND (Mic)
8 - GND (STBY)
Expander 500 Wiring:
WHITE - AUDIO
SHIELD - GROUND
YELLOW - SPEAKER SWITCHING
BLACK - RX
BLUE - TX
RED - B+ VOLTAGE
Expander 500 to Kenwood:
1 - White
2 - blue
5 - Red
7 - Shield |
Tech808
Moderator
Username: Tech808
Post Number: 4801
Registered: 8-2002
| | Posted on Thursday, February 10, 2005 - 6:53 pm: |
|
Af579,
Turner Expander500 is:
WHITE ~ AUDIO
SHIELD ~ GROUND
BLUE ~ TRANSMIT
BLACK ~ RECEIVE
RED ~ COMMON
YELLOW ~ AUDIO SW
Sorry can't help you with the Kenwood mic wiring.
Might be a good Question to post in the Ask The Tech » Ham Gear area.
Lon
Tech808
CEF808
N9OSN
|
Racer X (Unregistered Guest)
Unregistered guest
| | Posted on Thursday, February 10, 2005 - 7:30 pm: |
|
I mistunderstood what I was looking at in the Turner microphone book and I don't think you should connect the red wire to pin 5. I mistakenly thought it was there to power the microphone from the radio if it was available and instead it for isolated switching of transmit and receive.
Just wire it up this way:
Expander 500 to Kenwood:
1 - White
2 - blue
7 - Shield |
