| Author |
Message |
    
Ohiobiker
Member
Username: Ohiobiker
Post Number: 94
Registered: 12-2001
| | Posted on Friday, January 21, 2005 - 4:55 am: | 
|
I am looking for information on this freq. expander.(Kemscan KS-1) It is presently wired on a old Cobra-139 Base useing the 858PLL, what I need/want to do is remove it from this radio and have it installed on a President Washington useing the same style 858PLL chip. If someone could direct me to where as to find such instuctions I would be quite thankful. One of the very 1st bases I owned was a Washington with one of these boxes on it, and for nostogic reasons I want one again. At one time I did have the lititure on the piece but in my last move(12/?/04) I seem to have misplaced it for the time being. I want/need to get this switched over as soon as possible. Thanks and God Bless America and Our Troops CEF-309 OHIOBIKER "575"
TA-5275 |
Ohiobiker
Member
Username: Ohiobiker
Post Number: 95
Registered: 12-2001
| | Posted on Thursday, January 27, 2005 - 4:58 am: |
|
Maybe if I bring it to the top of the list again??? It may jar a memorie or two? Thanks for your attention to my problem! ...OHIOBIKER "CEF309" (Trans-America 5275) "WORLDWIDE-OPERATOR"-"575" Walter |
Bruce
Senior Member
Username: Bruce
Post Number: 2137
Registered: 9-2003
| | Posted on Thursday, January 27, 2005 - 7:20 am: |
|
Hummmm i found NOTHING on that device ...... how old is it ??????? |
Racer X (Unregistered Guest)
Unregistered guest
| | Posted on Thursday, January 27, 2005 - 5:05 pm: |
|
If it's still installed you should be able to label the wires, draw a schematic, and install it on the other radio. About the only variables would be the power source, which pc board traces were cut, and if there were buffering resistors installed - and you should be able to recognize that in the current installation.
Just curious - does this device totally replace the PLL or does it just control it? |
