| Author |
Message |
    
Buck
| | Posted on Saturday, December 28, 2002 - 6:21 am: | 
|
I need a schematic for a Dosy TC-4001-P. I can not get the Mod function to calibrate on AM mode....I run out of dial before it gets calibrated... seems to work ok on ssb. Has anyone ever had this problem?? |
Karatebutcher
| | Posted on Saturday, December 28, 2002 - 11:51 am: |
|
Buck I have had that problem twice and all I have done is check my connections to the meter, turned the radio off then on, and each time it worked |
Buck
| | Posted on Sunday, December 29, 2002 - 8:07 pm: |
|
This thing will calibrate on channel 1 but not on 40...I run out of dial....Same thing out of the regular 40....some channels it will calibrate on and some it wont....any ideas anyone?? |
Dx431
| | Posted on Sunday, December 29, 2002 - 10:20 pm: |
|
Have you checked your pl connectors? I find that one bad connector, it will not operate correctly. That would be one place to start. |
Alsworld
| | Posted on Monday, December 30, 2002 - 10:28 am: |
|
Buck,
I have the 4002PSW meter. On mine, I must have the radio deadkey no lower than 4 1/2 - 5 watts or it will do the same in all calibration/set modes. I'm lucky I have variable power to turn it up and down. I set it that way.
I don't have the answer but a similar experience with a similar Dosy.
Alsworld
799 North West Florida |
|
