Copper Talk » Open Forum » Archived Messages » 2002 » 09/01/2002 to 09/30/2002 » Bruce -cophase question on two antron99's « Previous Next »

Author Message
Top of pagePrevious messageNext messageBottom of page Link to this message

bullet/151 southern Indiana
Posted on Friday, September 13, 2002 - 12:59 pm:   Edit Post Delete Post    Move Post (Moderator/Admin Only)

ive cophased 2 antron's vertically and made a harness out of rg11,no certain length but made sure they were exactly the same length on each side of the tee conector. ive got them spaced about 4-6 feet apart from the bottom of the top one to the top of the lower one,witch uses a pdl2 boom as a stand off from the tower. it has a vswr
of about 2:1 witch is much higher than i like to run.
i first installed this set up on a hinged 25ft pole and it worked great for me on it with a vswr
of 1.3:1 and seemed very broad banded it covered
24.80's to 29.teens with under a 2 vswr. not the case now it seems to have the normal band width of
a single antron 99.(witch may be corect anyway?)

i did no special tuning, both had a good vswr as singles so i through them up. should i have tuned them in one at a time with the cophasing harness and a dummy load as the other antennas and switch over and do the other to get a more proper match
between antennas?

id like to run this setup as i can tell a differance in both rx and tx over a single antron
but would like your input on this matter
thanx bullet
Top of pagePrevious messageNext messageBottom of page Link to this message

Marconi
Posted on Friday, September 13, 2002 - 2:34 pm:   Edit Post Delete Post    Move Post (Moderator/Admin Only)

Well Bullet, what do you think the difference is? Since you ruled out the phasing harness as being the problem, there should be no difference. I doubt it, but the additional mass of the tower could come into play here.

Does it still show an improvement over a single A99 when attached in the new position? With the exception of the mounting position, is the system, including the feed line, exactly the same?

Marconi
Top of pagePrevious messageNext messageBottom of page Link to this message

bruce
Posted on Friday, September 13, 2002 - 2:38 pm:   Edit Post Delete Post    Move Post (Moderator/Admin Only)

bullet e-mail me so i can find the corect information

WA4GCH@YAHOO.COM
Top of pagePrevious messageNext messageBottom of page Link to this message

bullet
Posted on Saturday, September 14, 2002 - 2:18 am:   Edit Post Delete Post    Move Post (Moderator/Admin Only)

marconi

ive not ruled out the harness yet,yes it has improved rx/tx over a single a99,every things exactly the same. except its now on the tower.
and im thinking its two close to it at 6 foot.and maybe i could have tuned them in together to better things abit?