Copper Talk » Open Forum » Archived Messages » 2002 » Archived Messages 02/01/2002 to 04/31/2002 » Cobra 2000 question « Previous Next »

Author Message
Top of pagePrevious messageNext messageBottom of page Link to this message

Rosco
Posted on Saturday, February 23, 2002 - 12:44 am:   Edit Post Delete Post    Move Post (Moderator/Admin Only)
The cobra 2000 GTL standing wave and modulation meter, Is there a pod inside to adjust the meter needle, to bring it to rest on the number one setting. When not in use my needle rest all of the way to the left. Thank you in advance for Any one who can answer my question.

Rosco
Top of pagePrevious messageNext messageBottom of page Link to this message

Viking
Posted on Saturday, February 23, 2002 - 1:44 pm:   Edit Post Delete Post    Move Post (Moderator/Admin Only)
If there is, it's going to be on the face of the meter itself (not visable unless physically removed). There are adjustments for upper end readings (ie actual/calibrated modulation).
Top of pagePrevious messageNext messageBottom of page Link to this message

Rosco
Posted on Saturday, February 23, 2002 - 5:53 pm:   Edit Post Delete Post    Move Post (Moderator/Admin Only)
Thank you Viking, I will just leave it alone, I have another meter inline. Vr-7 pod is the upper reading adjustments according the the book, I have from Copper. rosco
Top of pagePrevious messageNext messageBottom of page Link to this message

Viking
Posted on Monday, February 25, 2002 - 12:30 am:   Edit Post Delete Post    Move Post (Moderator/Admin Only)
No problem. Yes, VR-7 is modulation. ...and just for the heck of it... VR-6 is for your RF-power meter, VR-1 is for AM s-meter receive and VR-2 SSB s-meter receive.