| Author |
Message |
    
Conner
New member
Username: Conner
Post Number: 2
Registered: 2-2014
| | Posted on Monday, February 24, 2014 - 1:27 am: | 
|
Thinkn bout gettn a 2970n2 from Copper. (wouldnt go nowhere else) And a power supply, Would the Pyramid 46 amp copper sells hold it? |
Sitm
Advanced Member
Username: Sitm
Post Number: 501
Registered: 1-2004
| | Posted on Monday, February 24, 2014 - 2:15 pm: |
|
RCI-2950DX & RCI-2970N2 Specifications
General
RCI-2950DX & 2970N2
Frequency Range
10 Mtr: 28.000 - 29.6999 MHz
12 Mtr: 24.8900 - 24.9900 MHz
Tuning Steps
1 MHz, 100 KHz, 10 KHz, 1 KHz, 100 Hz
Emission
USB, LSB, CW, AM, FM
Frequency Tolerance
0.005%
Frequency Control
Microprocessor / Phase-Locked-Loop Synthesizer
Frequency Stability
0.001%
Operating Temperature Range
-10 ºC to + 50 ºC
Meter Function
RF Output, RX Signal Strength, Modulation, SWR
(LCD Display Indicates Relative Values)
Antenna Impedance
50 W
Input Voltage
13.8 Vdc
Microphone
400 W Dynamic PTT - 6 Pin
Size (W x D x H)
2950DX - 7 3/4 " x 10 3/4 " x 2-3/8"
2970N2 - 7 7/8" x 11 1/8" x 3 1/4"
Weight
2950DX - 4 lb 3 oz
2970N2 - 8 lb 3 oz
Shipping Weight
2950DX - 7 lb.
2970N2 - 11 lb
Transmitter
RF Power Output
RCI-2950DX - 10 Watts RMS: CW / AM / FM
25 Watts: SSB (PEP)
RCI-2970N2 - 100 Watts RMS: CW / AM / FM
200 Watts: SSB (PEP)
Current Draw @ Full Power (PEP)
RCI-2950DX - 8 Amps
RCI-2970N2 - 32 Amps
Modes
USB, LSB, CW, AM, FM, PA
CW Keying
Semi break-in
Carrier Suppression
- 50 dB
Spurious Emission
- 50 dB
Antenna Connector
UHF Type, 50 W
Receiver
Sensitivity
AM / CW: 0.5 µV for 10 db SINAD
FM: 0.25 µV for 12 db SINAD
SSB: 0.15 µV for 10 db SINAD
Selectivity
- 55db
Image Rejection Ratio
- 65 db
Audio Output Power
2.5 Watts @ 10% THD into 8 W |
Sitm
Advanced Member
Username: Sitm
Post Number: 502
Registered: 1-2004
| | Posted on Monday, February 24, 2014 - 2:22 pm: |
|
Pyramid PS52kx
Perfect for Home, Shop and Hobbyist
Built-in Cooling Fan
Input: 115V AC, 60Hz, 1000 Watts
Output: 12~15V DC(Adjustable)
46 AMP Constant/52 AMP Surge
Powers 12V DC Devices such as Cellular Phones, CB Radios, Scanners, Ham Radios, Autosound Systems,etc.
Screw Terminal Connectors
Crowbar Over Voltage Protection
Short Circuit Thermal Protection
Fuse Protected
Linear Power Supply
LED Condition Indicators
3 Prong Grounded AC Plug
Heavy Duty Rack Mountable Cabinet Heatsink
Electronic Overload Protection w/Auto Reset
Dimensions: 12''L x 19''W x 4.5''H
Please see my last post on the 2970, in the specs, look at the requirements.
On the specs for the Pyramid, look at the peak amp output.
Always purchase a power supply that will product 10% more than your intending to utilize. |
Conner
New member
Username: Conner
Post Number: 3
Registered: 2-2014
| | Posted on Monday, February 24, 2014 - 8:03 pm: |
|
I've ordered the Pyramid PS 52KX 46 Amp already, but I never run a radio wide open, I just hope this 46 holds up, U think?It states 48 Continuous Duty Amps |
Dale
Senior Member
Username: Dale
Post Number: 2040
Registered: 12-2002
| | Posted on Tuesday, February 25, 2014 - 6:19 pm: |
|
should be ok. just watch the amp meter and see what
its drawing. if its maxing out cut your rf power
back.
dale/a.k.a.hotrod
cef426
cvc#64
454 [dx numbers]
38lsb
|
Conner
New member
Username: Conner
Post Number: 7
Registered: 2-2014
| | Posted on Tuesday, February 25, 2014 - 6:42 pm: |
|
Thanks Dale |
Sitm
Advanced Member
Username: Sitm
Post Number: 508
Registered: 1-2004
| | Posted on Wednesday, February 26, 2014 - 9:14 am: |
|
Yeah, thanks Dale. |
Conner
New member
Username: Conner
Post Number: 9
Registered: 2-2014
| | Posted on Wednesday, February 26, 2014 - 10:39 pm: |
|
You too Sitm. I'm sure I'll have more questions later, appreciate it. |
Conner
Junior Member
Username: Conner
Post Number: 11
Registered: 2-2014
| | Posted on Thursday, February 27, 2014 - 7:52 pm: |
|
That wqs Quick, ordered a 2970n2 Mon eve, Came 2day.Just one Q. Anyone know why theres not a warranty seal on it?. They used 2 be on the side, Dont see one. Suppose they just 4got?
Customer Service Note : If you had any service work performed the seal would have been removed for that. |
Dale
Senior Member
Username: Dale
Post Number: 2042
Registered: 12-2002
| | Posted on Friday, February 28, 2014 - 6:26 pm: |
|
yw conner. hows it working?what powersupply
ya get
dale/a.k.a.hotrod
cef426
cvc#64
454 [dx numbers]
38lsb
|
Conner
Junior Member
Username: Conner
Post Number: 12
Registered: 2-2014
| | Posted on Saturday, March 01, 2014 - 2:33 am: |
|
psk52,but radio not good on am, dead key one half watt on low, only 65 on high & backs up on mod. to 60, I tried another radio on the new ant, & it its ok, swr less than one. I'm sure copper will help me, this is the 3rd rci i've got from em, first one thats not perfect, But power supply seems 2 hold good, got a99 coax, dosy meter whole outfit, Just gonna be a long weekend till Mon. |
Conner
Junior Member
Username: Conner
Post Number: 14
Registered: 2-2014
| | Posted on Saturday, March 01, 2014 - 5:14 pm: |
|
Anyone ever notice ur amp meter on your power supply on SSb?, mine is showing bout 6 amps pull while im keyed on ssb before I speak Then when I speak it shows normal amperage swing with audio, but watt meter & radio meter show no sound is coming through till I speak, Thats with the stock mic, so its not background. Is this normal? |
|
