| Author |
Message |
    
Ace50252
New member
Username: Ace50252
Post Number: 1
Registered: 9-2005
| | Posted on Sunday, September 18, 2005 - 12:42 pm: | 
|
Hello, what I have is a cobra 148 gtl and a texas ranger fc 390. I solder the wires in just like the instructions told me to do and double checked my work. I turned on the frq. counter and radio and it reads 45mhz in the 27 mhz area. I looked at the instructio again and had seen I needed to do a JP1 solder jumper in the frq. counter. This where the real problem begains, the freq. counter I have is different then the instructions. The insrtuction shows EPT210014C board. What I have is EPT 210014D. I did not see a JP1 jumper unless it is on the bottom of the board. If anyone has info on this I would be greatfull if you could share it with me. I did go back to the radio shop where I bought this freq. counter. They look for info but could not find anything as well. A week has went by and I had herd nothing from them. They have there money now so I guess, it's in there best intrest to give me the run a round on it. You can contact me at ace50252@direcway.com and thank so very much in advance!!! |
Fusebreaker
Intermediate Member
Username: Fusebreaker
Post Number: 194
Registered: 3-2004
| | Posted on Sunday, September 18, 2005 - 11:46 pm: |
|
It appears jp1 is by the little transister side of the board man why do they make these things so hard |
Ace50252
New member
Username: Ace50252
Post Number: 2
Registered: 9-2005
| | Posted on Monday, September 19, 2005 - 6:54 pm: |
|
Thanks for the info JP1 jumper is the trick to it! I figured it had to be some where but did not what to void waranty on this 80 dollar freq. counter just in case I had to return it. And thank you so very much for your knowledge. Your friend ACE and 73's to ya!! |
Fusebreaker
Intermediate Member
Username: Fusebreaker
Post Number: 197
Registered: 3-2004
| | Posted on Tuesday, September 20, 2005 - 2:42 am: |
|
im glad you got it working
73`s fusebreaker/kc0kgs |
