| Author |
Message |
    
Rficon
Junior Member
Username: Rficon
Post Number: 22
Registered: 2-2005
| | Posted on Monday, February 28, 2005 - 2:49 pm: | 
|
On my Connex 4800, the clarifier mod that was done is nothing that I have seen before.
It consists of a transistor(3 leg, info scraped off)(flat side up and legs down) the right leg is connected to a wire going to 8v off of IC8, the middle leg is connected to F1 in J9, and the left leg goes to R153(I think). And D68 and R113 are removed.
Can anyone tell me the transistor that is used? With the info scraped off I have no idea what value it is. One of the legs broke off and I need to replace it.
Any information would be greatly appreciated.
RFIcon |
Rficon
Junior Member
Username: Rficon
Post Number: 24
Registered: 2-2005
| | Posted on Monday, February 28, 2005 - 4:55 pm: |
|
Here is a graphic, showing how it is hooked up.
Moderators Note!
Your post was edited for the reason below.
The graphic you tried to post is copyrighted.
Forum Membership
Register
Forum Rules
Copyrighted Material
You will not post, distribute or reproduce in any way any copyrighted material, trademarks, or other proprietary information without obtaining the prior written consent of the owner of such proprietary rights. Exceptions to this standard are covered by the Federal law regarding fair use, 17 USCS 107, and related case law, which holds that only partial excerpts of copyrighted material may be reproduced, and only as necessary for criticism or comment.
|
|
